14
12. Remove the Pointer and reattach it to the Operators Left hand side of
the machine. NOTE: Reverse the orientation of the Pointer
13. Reconnect the spark plug.
C. Engine Operation
Prior to attempting to operate the engine, read the information
contained in the engine owner's manual. An engine owner’s manual
is supplied with every gasoline powered concrete saw.
1.
Check Oil:
Add oil if low. Refer to the engine owner's manual for the
recommended SAE viscosity grades. Capacity of oil is 1.1 liters (1.16 US qt)
2. Check Fuel:
Fill if low. Use only unleaded gasoline with a pump sticker
octane rating of 86 or higher is recommended.
Never use an oil and
gasoline mixture!
3.
Air Cleaner:
Never run the engine without the air cleaner! Rapid engine
wear will result from contaminants being drawn through the carburetor and
into the engine.
4.
Engine Starting:
Refer to the engine owner's manual for detailed engine
starting procedure.
5.
Engine Speed:
Always run the engine and the proper speed for the blade
being used. Never run the blade at a higher speed that it is rated for. See
the Blade Speed chart located on the machine’s console or located in the
manual under the heading “Operating the Saw”
6. All 13 HP units are equipped with a Choke control attached to the Engine
below the Air Cleaner on the Operator’s Right Hand Side.
D. Starting the Engine
1. Refer to the engine owner's manual for detail starting procedures.
2. Always cut with engine rpm in the full throttle setting.
Summary of Contents for C1320P
