Service as Required
RG19661,0000404 -19-07MAR13-1/1
Remove and Install Sea Water Pump (6068SFM85)
RG22485
—UN—04MAR13
Remove and Install Sea Water Pump
RG22484
—UN—07MAR13
1. Close sea cock and drain sea water system.
2. Remove sea water pump inlet connection. Loosen
constant tension clamps (B) on formed hose (C) that
is attached to the aftercooler inlet (A).
3. Remove sea water pump bracket cap screws (D).
Remove pump mounting nuts (E) and remove sea
water pump (H).
4. Clean sealing surfaces and inspect for defects.
Replace O-ring (G) if necessary.
5. Install sea water pump with O-ring on studs (F). Install
nuts (E) finger-tight evenly on both studs and tighten
to 60 N·m (44 lb.-ft.).
6. Install bracket cap screws (D) and tighten to 35 N·m
(26 lb.-ft.)
7. Install formed hose (C) and tighten constant tension
clamps (B) to 12 N·m (9 lb.-ft.).
8. Connect sea water pump inlet.
9. Open sea cock, start engine and check for leaks.
RG22483
—UN—07MAR13
A—Aftercooler Inlet
B—Constant Tension Clamps
C—Formed Hose
D—Cap Screws
E—Nuts
F— Studs
G—O-ring
H—Sea Water Pump
OM-C3 | 12/6 | 72
Summary of Contents for M65C13
Page 11: ...Notes OM C3 12 6 9...
Page 121: ......
