Service as Required
RG19661,00003FE -19-02MAR13-1/1
Remove and Install Sea Water Pump
(4045TFM85)
NOTE: Sea water pump may have two more mounting
cap screws than illustrated. Remove/install
procedure is unchanged.
•
Remove Sea Water Pump:
1. Close sea cock and drain sea water system, if not
previously done.
2. Remove water inlet tube (shown removed) and outlet
tube (A) from sea water pump.
3. Remove two cap screws (B) attaching sea water pump
to gear housing. Withdraw pump from housing until
splined shaft (C) is free from splined drive gear ID (D).
4. Clean all gasket material from both mating surfaces.
•
Install Sea Water Pump:
1. Position a new gasket on water pump mounting flange.
Install splined pump shaft in splined ID of drive gear.
2. Align mounting holes in water pump flange and gasket
with threaded holes in gear housing. Install cap screws
with washers and tighten cap screws to 47 N•m (35 lb-ft).
3. Connect water piping and tighten clamps.
4. Open sea cock, start engine, and check for leaks.
RG9861
—UN—06JAN99
Remove Sea Water Pump
RG9864
—UN—06JAN99
Install Sea Water Pump
A—Outlet Tube
B—Mounting Screws
C—Splined Shaft
D—Drive Gear Splined ID
OM-C3 | 12/6 | 70
Summary of Contents for M65C13
Page 11: ...Notes OM C3 12 6 9...
Page 121: ......
