Northern Lights M65C13, Operator'S Manual

Page: 20 / 122

Engine Operation
RG19661,00003BD -19-23JAN13-2/2
IMPORTANT: Do not operate the starter for more
than 30 seconds at a time. To do so may
overheat the starter. If the engine does not start
the first time, wait at least 2 minutes before
trying again. If engine does not start after four
attempts, see Troubleshooting Section.
If the start switch button is released before
the engine starts, wait until the starter and
the engine stop turning before trying again.
This will prevent possible damage to the
starter and/or flywheel.
NOTE: Key switch (A) on main (standard) instrument
panel must be in “ON” position to start engine using
fly bridge (optional) instrument panel.
6. Press start button (B) to crank the engine. When the
engine starts, release the button.
7. After the engine starts, observe the oil pressure
gauge (C) until it reads at least the slow idle pressure
specified for your engine in the Specifications Section.
8. Warm up the engine at or below 1200 rpm with no load
for 1-2 minutes. See following guidelines.
9. Check all gauges for normal engine operation. If
operation is not normal, stop the engine and determine
the cause.
10. Check sea water outlet for water flow. Check exhaust
pipe for water flow on engines with wet exhaust
systems.
If sea water does not flow within one minute after
engine starts, stop engine and check sea cock, sea
water strainer, and sea water pump for restrictions.
A—Key Switch
B—Start Button C—Oil Pressure Gauge
D—Warning Light
RG13291
—UN—06NOV03
Start Engine - Mechanically Controlled Engine
RG13134
—UN—07OCT03
Start Engine - Electronically Controlled Engine
OM-C3 | 12/6 | 18