N
ORTEL
TPS 3D S
ENSOR
AND
D
EFENSE
C
ENTER
I
NSTALLATION
G
UIDE
R
ELEASE
4.7.0
PAGE
27
Chapter 2: Installation
TPS 2070 DC
5.
To determine the name of the management interface, enter the following
command: grep MANAGEMENT /etc/sf/ims.conf
6.
To configure the management interface, enter the following command:
ifconfig eth# ipaddr netmask mask broadcast bcastaddr
where eth# is the result you received for the command in the previous step, and
ipaddr, mask, and
bcastaddr
are the values you want to use in your network
environment.
For example:
ifconfig eth0 192.168.10.5 netmask 255.255.255.0
broadcast 192.168.10.255
7.
If the Defense Center is on a different subnet from the web browser, add a
default route as shown in the following command:
route add default gw gw_addr
where gw_addr is the IP address of the default gateway.
For example:
route add default gw 192.168.10.1
8.
Continue with
“Performing the initial setup” on page 27
.
Performing the initial setup
After you physically install the Defense Center and set up the IP address for the
management interface, you must log into the Defense Center's web interface and
continue the setup process. After you perform the initial setup, refer to your user
guide for information about the next steps you need to take.
See the following sections for more information:
•
“Accessing the web interface” on page 27
•
“Changing the default password” on page 28
•
“Configuring the network settings” on page 28
•
“Setting up the base license” on page 30
•
“Setting up remote management” on page 30
•
“Installing software updates” on page 31
•
“Importing SEUs and rule files” on page 31
•
“Configuring a system policy” on page 32
Accessing the web interface
1.
Connect to the management interface securely to access the GUI.
To access the GUI through the management interface, browse to the IP
address you configured in the previous procedure, for example,
https://192.168.10.5
.
The Login page appears.
Summary of Contents for Softphone 2050
Page 56: ......
