Picocell 1900 Radio Unit Installation / 17
September 3, 1998
Method 02-0245
Draft
Procedure 3 – Ceiling Mounting and securing the Radio Mounting Bracket
Step
Action
Observation
1
Locate the wall mounting bracket and
the screws provided. Determine the
desired direction of the wall mount
bracket orientation. Refer to the system
layout document to determine readio
orienation.
2
Locate the ceiling main support track
closest to the desired mounting location
and attach the IDS clips as shown in Fig-
ure 6 . If the ceiling track is poorly sup-
ported use drop wire from each IDS clip
to a secure point above the mouning
location in main ceiling. Replace the
ceiling panel
Figure 6
3
Attach the mounting bracket to the ceil-
ing as shown in Figure 7 using spacers
between the bracket and the IDS clips.
Note that the nuts on the IDS clips must be flusch
to permit the transciever to lock into the mount-
ing bracket to
Appendix B
4
Drill an access hole near the front of the
transciever for the facility cable pairs.
5
Lock the transciever into the bracket and
complete the wired connections.
