Nortel Modular ICS 7.1, Install Manual

Page: 556 / 700

556
/ Event messages
Modular ICS 7.1 Installer Guide N0130943 02
Significant event messages
The following table lists event messages that are relevant to
Maintenance activities. The time that the message is recorded
is also provided.
Displays
Event message The event message is recorded when…
Evt:210-YYYZ S4
Loopback test YYY on Trunk Cartridge Z has
started
Evt:211-YYYZ S4
Loopback test YYY on Trunk Cartridge Z has
stopped
Evt:220-3546 S4
the Sys admin log has been cleared by the DN
(3546 in this case)
Evt:221-3546 S4
the Sys test log has been cleared by the DN (3546
in this case)
Evt:222-3546 S5
the DN (3546 in this case) enters the debugging
facility that is password protected
Evt:255 S9
administered mode is not supported by the cartridge
plugged into the slot
Evt:260-0302 S8
the ICS takes the access line on port 0302 out of
service because no current was detected
Evt:261-0302 S1
the access line on port 0302 is returned to service
after current was detected (see Evt:260)
Evt:263-302 S8
the ICS takes the E&M line on port 302 out of
service because the far end did not respond to a
disconnect signal
Evt:264-302 S1
the E&M line on port 302 is returned to service after
the far end finally responded to a disconnect signal
(see Evt:263)
Evt:265-302 S7
the E&M line on port 302 did not receive an
expected wink signal or delay dial signal from the far
end
Evt:267 S9
a data module has been disconnected
Evt:268-07 S8
Dialing filter 07 has lost data due to a fault in the
system memory