4
Mounting the Tilt Sensor
The battery powered Tilt Sensor attaches to the top panel of the garage door.
1.
Before installation, activate the Tilt Sensor by pulling and removing the battery protection strip.
2.
If using screws to mount the Tilt Sensor, open the sensor case with a small screwdriver.
3.
Use the double-sided tape or screws supplied to attach the Tilt Sensor to the top panel of the
garage door.
✓
NOTE:
Drill two 1/16” pilot holes if using the screws to attach the mounting plate .
4.
If the plate was removed for screw mounting, snap the Tilt Sensor on to the mounting plate.
✓
NOTE:
Be sure the arrow on the side of the Tilt Sensor points UP .
Tilt Sensor Installation
Use double sided tape or the two mounting
screws supplied.
(DRILL 1/16" PILOT HOLES IF REQUIRED)
POST ON
BOTTOM
"UP"
ARROW
Snap the tilt sensor onto the
mounting plate.
To activate the tilt sensor, remove the
battery protection pull strip.
2
ARROW
ON PLATE
POINTS UP
1
4
Attach mounting plate
to
TOP PANEL
of the door.
To open the case, for screw
mounting, twist a small
screwdriver in the case slot.
ARROW
ON SENSOR
POINTS UP
SLOT
3
Figure 3. Tilt Sensor Installation