20
1. Before the gas conversion is performed, verify
the proper gas conversion kit with your Water
Heater model on the table provided below.
2. The following parts are supplied in the
conversion kit. These items will replace the
existing parts that are currently installed in the
Water Heater.
3. After the necessary parts have been replaced on
the Water Heater, the Remote Controller is then
used to adjust the settings on the Water Heater
for use with the proper gas type.
4. The following pressure value are verified by the
installer.
- The inlet gas pressure value at the gas supply
inlet fitting
- The offset pressure value at the gas valve
5. Proper adjustments will be made to ensure safe
and efficient operation.
6. Once this is completed, a final gas leak check
will be performed to confirm that all parts have
been securely installed.
NOTE
• Make sure that all parts are
replaced and properly installed by a
qualified service agency.
• A Noritz Remote Controller and a
digital gas manometer are required
to complete the installation. Do not
proceed if this Water Heater is not
immediately available.
NOTE
If you notice the smell of gas at any
time after the installation has been
completed, turn the Water Heater
off and contact your gas supplier
immediately.
Conversion Kit
Conversion Type
CK-82
Propane to Natural Gas
CK-83
Natural Gas to Propane
Venturi Mixer Set
O-Ring (× 2)
Conversion Kit Label
Gas Conversion
Connector*
* This connector is
including in only CK-82 to
convert from Propane to
Natural Gas.
Follow-up Service
Summary of Contents for EZ111
Page 24: ......
