Nordson iDry
r
Series Induction Dryers
23
Part 1075452
−
04
E
2016 Nordson Corporation
12. Touch the
RAMP/MOTION
button. The Timer and Ramp Control screen
13. On the Timer and Ramp Control screen, touch the
RAMP POWER
field
and use the screen keypad to adjust ramp power to the % Power setting
on the Manual Control screen.
14. Touch the
ENT
key to save your setting.
Ramp Timer Setting
The Ramp Time is the time it takes for a can end to travel the length of the
dryer, from the entrance to the exit. This time is dependent on your line
speed. The factory default is 60 seconds.
1. Mark a can end in the line ahead of the dryer.
2. Start the line and time the end as it travels through the dryer.
3. On the Timer and Ramp Control screen (Figure 18), touch the
RAMP
TIMER
field and set the time with the keypad.
4. Touch the
ENT
key to save your setting.
Motion Timer Setting
The Motion Timer setting delays turning off coil power when can end motion
stops. This prevents control cycling to ramp mode each time the line
momentarily stops. The factory default setting is 3 seconds. Do not set the
motion timer for more than 5 seconds.
The recommended settings are:
S
2 seconds for lines with continuous motion
S
3 seconds for lines with intermittent motion
1. On the Timer and Ramp Control screen (Figure 18), touch the
MOTION
TIMER
field and set the time with the keypad.
2. Touch the
ENT
key to save your setting.
Motion Detect Sensitivity Setting
The Motion Detect Sensitivity setting adjusts the time cycle of motion pulses
from the motion sensor. This can be useful for extreme line speeds (less
than 300 ends per minute or more than 1600 ends per minute).
The factory default setting is 30. Recommended settings per line speed
are:
S
Less than 750 ends/minute: 30
−
35
S
750
−
1500 ends/minute: 25
−
30
S
Greater than 1500 ends/minute: 20
−
25
1. On the Timer and Ramp Control screen (Figure 18), touch the
Motion
Detect Sensitivity
field and set the time with the keypad.
2. Touch the
ENT
key to save your setting.