Nordson DuraBlue D10L, Customer Product Manual

Page: 22 / 164

Introduction
2-4
Part 1032059B
E
2003 Nordson Corporation
Manual 41-DURABLUE-MA-02
Modes of Operation
DuraBlue melters operate in the following modes:
Automatic scan—The melter automatically checks and displays the
current temperature of the tank, hoses, and guns to confirm that they
are within their pre-defined temperature range. By default, the melter is
always in the automatic scan mode unless it is placed into another
operating mode.
Standby—The temperatures of the tank, hoses, and guns are reduced
down from their operating temperature (hereafter referred to as set-point
temperature) by a pre-set number of degrees.
Setup—The setup mode is used to configure melter control options and
features and to review stored operating data. To prevent unauthorized
changes to the melter’s configuration, the melter can be
password-protected
Fault—The melter alerts the operator when an abnormal event occurs.
Melter Identification
See Figure 2-2. You will need the model and part number of your melter
when requesting service or ordering spare parts and optional equipment.
The model and part number are indicated on the equipment identification
plate that is located on the front of the melter.
Figure 2-2 Equipment identification plate