29
HOW TO ADJUST THE DRIVE BELT
If the pedals slip while you are pedaling, even while the
resistance is adjusted to the highest setting, the drive
belt may need to be adjusted.
To adjust the drive belt, first
unplug the power
adapter (not shown).
Next, use an
adjustable
wrench to turn
the Left Pedal
(22) clockwise
and remove it.
See EXPLODED DRAWING A on page 34.
Using
a standard screwdriver, gently release the tabs on the
Front Shield (58) and the Top Shield (44) and remove
them.
Next, locate the Left and Right Front Shields (13, 14).
Remove all the Screws (77, 85) from the Left and Right
Front Shields;
make sure to note the location of
each size of Screw.
Using a standard screwdriver, gently release the tabs
on the left Shield Disc (52). Rotate the Shield Disc
and remove it. Then, gently remove the Left Front
Shield (13).
Next, loosen the M6 x 20mm Hex Screw (84). Tighten
the M10 x 50mm Hex Screw (83) until the Drive Belt
(47) is tight. When the Drive Belt is tight, tighten the
M6 x 20mm Hex Screw.
When the drive belt is correctly adjusted, reattach the
left and right shields, the top shield, the front shield,
the left pedal disc, and the left pedal. Then, plug in the
power adapter.
22
83
47
84
Summary of Contents for ELITE 7.4
Page 4: ...4 ...
