12
HOW TO USE THE MANUAL MODE
Note: If there is a sheet of clear plastic on the face of
the console, remove the plastic.
Press any button on the console or begin
pedaling to turn on the console.
When you turn on the console, the display will
light. A tone will then sound and the console will
be ready for use.
Select the manual mode.
When you turn on the console, the manual mode
will be selected. If you have selected a program,
reselect the manual mode by pressing the Heart
Rate Programs button repeatedly until zeros
appear in the display.
Begin pedaling and change the resistance of
the pedals as desired.
As you pedal, change the resistance of the ped-
als by pressing the OneTouch Resistance but-
tons. There are sixteen resistance levels. Note:
After you press the buttons, it will take a moment
for the pedals to reach the selected resistance
level.
Follow your progress with the display.
While you pedal, the upper left corner of the dis-
play will show the elapsed time.
The lower left corner of the display will show your
pedaling speed, in miles or kilometers per hour.
The upper right corner of the display will show
your heart rate when you use the handgrip pulse
sensor (see step 5 on page 13).
The lower right corner of the display will show the
distance that you have pedaled, in miles or kilo-
meters.
The center of the display will show the resistance
setting of the pedals for a few seconds each time
the resistance setting changes.
To view the approximate number of calories that
you are burning per hour and the approximate
number of calories that you have burned during
your workout, press the Display button.
You can also view selected information at a larger
size. Press the Display button repeatedly to view
the elapsed time, the distance that you have ped-
aled, your pedaling speed, or the approximate
number of calories that you have burned.
To again view the elapsed time, your pedaling
speed, and the distance that you have pedaled,
press the Display button again.
To view the total distance pedaled since the exer-
cise cycle was purchased and the trip distance,
press the Odometer button. The information will
appear in the display for a few seconds. To reset
the trip distance, hold down the Odometer button
for a few seconds.
Note: The console can show speed and dis-
tance in either miles or kilometers. To determine
which unit of measurement is selected, hold down
the decrease button below the Odometer button
for a few seconds. The words UNITS: ENGLISH or
UNITS: METRIC will appear in the display. Press
the increase button to change the unit of measure-
ment if desired. Then, press the decrease button
again. Note: When the batteries are replaced, it
may be necessary to reselect the desired unit of
measurement.
4
3
2
1
Summary of Contents for Audiorider U300 Bike
Page 20: ...20 NOTES ...
Page 21: ...21 NOTES ...
