11
7
7. Using a small plastic bag to keep your fingers
clean, apply a generous amount of the included
grease to the right axle on the Upright (2).
Next, identify the Right Handlebar Leg (13) and
orient it as shown.
See the inset drawing.
While a second person
holds the Right Handlebar Leg (13) near the
Upright (2), tie the indicated wire tie to the Right
Extension Wire (80). Then, pull the other end of
the wire tie through the Right Handlebar Leg.
Tip: Avoid pinching the Right Extension Wire
(80).
Slide the Right Handlebar Leg (13) onto
the axle on the Upright (2). Attach the Right
Handlebar Leg with an M10 x 20mm Screw (61)
and an M10 Washer (64).
Attach the Left Handlebar Leg (12) in the
same way.
13
Grease
64
80
12
100
61
2
8
8. Identify the Right Pedal Arm (15), the Right
Pedal (9), and the Right Pedal Insert (104), and
orient them as shown.
Attach the Right Pedal (9) and the Right Pedal
Insert (104) to the Right Pedal Arm (15) with six
M6 x 12mm Screws (78).
Attach the Left Pedal (not shown) and the
Left Pedal Insert (not shown) to the Left
Pedal Arm (not shown) in the same way.
9
15
104
78
Avoid pinching
the wires
Wire Tie
13
80
2