w w w . h a w k e y e e l e c t r o n i c s . c o m
•
NON-CORED hulls or aluminum hulls thinner than 1/8”.
•
Inboard vessels that have a lot of running gear that creates significant
turbulence.
N
OTICE
:
Glue-in mounting of the transducer is NOT suitable for all
vessels. You MUST test the glue-in location on the water prior
to using epoxy to permanently affix it to the hull. If you cannot
obtain satisfactory readings during on water testing you will need to
transom mount the transducer, or switch to a custom transducer.
If you think that the included transducer is not suitable for your installation visit
our Customer Service Center at www.hawkeyelectronics.com to contact us or to
complete a transducer exchange request to exchange the transducer for one that
is specialized for your vessel. You may also call 888-766-7276 to inquire about
exchanging the transducer.
INSTALLING THE DISPLAY
Tools & Supplies Required for Installation
•
Power Drill
•
19/32” (15 mm) Drill Bit, Hole Saw, or Spade Bit (Warning Buzzer
Installation)
•
1/2” (12 mm) Drill Bit, Hole Saw, or Spade Bit (LCD Display Plug Pass
Through)
•
1/16” (2 mm) Drill Bit (LCD Display Mounting Screws)
•
Wire Connectors Suitable for Connecting the Power Wire to Your Vessel
•
Wire Cutting/Crimping Tool
•
Zip-Ties
•
Marine Sealant
•
(4) Stainless Steel Screws or Bolts (DSM Mounting)
•
Silicon Grease or Petroleum Jelly
W
ARNING
:
Check behind the desired cutting area for wires, switches, etc. that
may be damaged during cutting. If these obstructions are present, use
masking tape to hold them out of the way during cutting.
