w w w . h a w k e y e e l e c t r o n i c s . c o m
STEP 3
Linking the System Wires
12 Volt Power Harness: (A)
The system has an ON/OFF switch as well as
an Auto Power-OFF feature. It is recommended
that you connect the power harness to a
constant power source such as a terminal block
or directly to the battery.
1.
Connect the BLACK wire on the DSM
harness to a
negative (-) terminal or
suitable ground.
2. Connect the RED wire on the DSM
harness to a positive (+) 12 Volt power
source.
The Alarm System: (B)
1. For extended waterproofing of the
connection, lubricate the plug by applying
a generous amount of silicon grease or
petroleum jelly to the ridge on plug
B
on
the DSM.
2. Firmly press plug
B
into the Alarm
Assembly’s plug.
IMPORTANT:
BE VERY CAREFUL WHEN
MAKING THE DISPLAY
CONNECTION. Improper
alignment of the plugs and
internal pins will cause unrepairable
damage to the connector.
The Display: (C)
1. Lubricate the plug by applying a
generous amount of silicon grease or
petroleum jelly to the Display Plug.
2. Align the arrows on the Display Plug and
Plug
C,
and gently, but firmly press them
together until the arrow on the display
plug touches Plug C’s housing.
