w w w . h a w k e y e e l e c t r o n i c s . c o m
3. Check the Display Plug Pins
a. Disconnect the display plug from the DSM.
b. Look inside the end of the display plug. If the pins are bent,
use a small screwdriver to straighten them.
c.
Reassemble making sure to properly align the arrows.
4. If you still can not get the system to turn on, visit our
Customer Service Center on our website or call 888-766-7276
for advanced technical support.
GETTING TO KNOW YOUR MICRO DEPTH SOUNDER
The HawkEye
®
Micro Depth Sounder’s auto-ranging, auto-
sensitivity
features mean that you never have to worry about
adjustments. Simply turn the power on, and you’re ready to
go. The DSM emits sound signals that travel through water,
and then calculates the amount of time that elapsed while
the signal traveled down to the bottom and returned back to
the transducer. This time is calculated by the DSM and
displayed as a depth reading on the LCD. Extremely dirty water, very soft bottom, high
speeds, improper transducer mounting, deep water, or a combination of the above will
result in incomplete or inaccurate readings. Under these conditions inaccurate readings or
“---” will be displayed.
POWERING THE DISPLAY ON AND OFF
To Power ON - Press and release the button on the front of the Display. The LCD
will display a test sequence and then switch to normal operation.
Manually Powering OFF - Press and HOLD the button for 5 Seconds. Release
when “OFF” is displayed on the display. The unit is now OFF.
Auto OFF Feature - to help save your battery if you forget to turn the D11S OFF,
the unit will automatically turn OFF if “---” is displayed on the LCD for 5
continuous minutes.
SETTING THE UNITS OF MEASURE
The units of measure for depth readout and alarm functions can be set in 4 easy steps.
The two settings available are Feet (FT) and Meters (M).
To Set the Units:
1.
Press and hold the button for 3 seconds until
the units indicator
(FT or M) blinks.
2.
To set the units to FEET press the button. “FT” will
flash on the Display.
3.
To set the units to METERS press the button. “M”
will flash on the Display.
