Norcold 121X series, Service Manual

Page: 94 / 100

92
S
ection
11
Reservoir Replacement Dispenser Switch Replacement
Tools
# 2 Phillips Screwdriver
1. Shut off the water supply to the valve.
2. Place a suitable container under the spigot
then operate dispenser to relieve water
pressure.
3. Power off the refrigerator.
4. Disconnect the water line at the valve and
place the end in suitable container to catch
the draining water. See Figure 11-7,

and

.
5. Remove the reservoir compartment cover.
See Figure 11-8,

.
6. Disconnect the dispenser water line at the
reservoir. See Figure 11-9

. Allow water to
drain into the container (placed in step 4).
7. Disconnect the water fill line from the
reservoir. See Figure 11-9

.
8. Remove the retaining screws, then pull the
reservoir out of the cabinet recess. See
Figure 11-9,

and

9. Reverse steps 8 through 1 to install
replacement reservoir.
Reservoir cover
held in place with
hook and loop tabs.

Figure. 11-7. —Draining reservoir before removal.
Figure. 11-9. —Reservoir fittings and retaining screws.
Figure. 11-8. —Cover, reservoir compartment.
To remove: pull out
evenly on top and
bottom edges
To install: place over
opening and seat
firmly
Press down to
disconnect fitting
from reservoir
Blue body
Red body
Press up to
disconnect fitting
from reservoir
Retaining screw

Retaining screw




