Norcold 121X series, Service Manual

Page: 85 / 100

S
ection
10
83
Water Fill Adjustment
The water fill adjustment is set at the factory.
The production of thin ice cubes indicate not
enough water in the mold. The ejector rocking
back and forth may indicate fused ice cubes
due to too much water in the mold. Both of
these conditions may require adjusting the
water fill to increase or decrease the time the
water valve remains open. To adjust the water
fill capacity screw:
1. Remove the ice bin and freezer shelf.
2. Detach the ice maker from the evaporator
plate. Do not to pull on the wire harness.
3. Rotate the ice maker so the module cover
faces toward the freezer door, then remove
the cover.
4. Rotate the ice maker so the shut-off arm is
facing towards the freezer door.
5. Locate the contact opening shown in Figure
10-12.
628135
D
O
N
O
T
R
OTATE
62
83
58
DISCONNECT POWER
TO MODULE
106 626649
IM
REMOVE
#S
W
2
01/13/03
185W–115V– 60 HZ
14
A
W
G
IN
SU
LA
TE
D
Figure 10-11. —Jumpering test points V and
L.
62
81
35
D
O
NO
T
ROTA
TE MA
NU
AL
LY
62
83
58
DISCONNECT POWER
TO
MODULE
106 626649 IM
REMOVE
#S
W 2
01/13/03
185W–115V– 60 HZ
Le
ssw
ate
r*
M
or
e
wa
ter*
Figure 10-12.. —Water adjustment screw and
contact alignment location.
Normal setting = internal contact
opening centered in module hole
Water fill adjustment screw
Do not exceed one turn
Do not turn the water fill adjustment screw if
the contact opening is centered in the module
hole. See Figure 10-12.
6. Turn the adjustment screw clockwise or
counterclockwise to align the center of the
contact with the hole in the module. See
Figure 10-12.
Do not turn the water fill adjustment screw
more than one turn. Turning the screw
more than one turn may damage the
contacts.
WARNING

NOTE