14
OPERATING INSTRUCTIONS
WARNING:
KEEP HANDS CLEAR OF THE REACTION ARM.
WARNING:
WHEN USING THIS TOOL IT MUST BE SUPPORTED AT ALL TIMES IN
ORDER TO PREVENT UNEXPECTED RELEASE IN THE EVENT OF
FASTENER OR COMPONENT FAILURE.
WARNING:
CHANGING THE MAINS AIR PRESSURE AFTER SETTING THE PRESSURE
REGULATOR WILL CHANGE THE STALL TORQUE VALUE.
WARNING:
BEFORE USING TOOL, WEAR SUITABLE PPE, INCLUDING SAFETY
SHOES, EYE PROTECTION, GLOVES AND OVERALLS.
WARNING:
IF EQUIPMENT IS USED IN A MANNER NOT SPECIFIED BY THE
MANUFACTURER, INJURY OR DAMAGE COULD RESULT.
Tightening
1. Fit PneuTorque
®
with the correct size impact or high quality
socket.
2. Ensure the external tool control system is correctly set.
3. Fit the tool onto the fastener. Locate reaction arm adjacent
to the reaction point.
4. Complete the following instructions for SINGLE SPEED,
AUTOMATIC TWO SPEED or MANUAL TWO SPEED
tools:
Single Speed (Part Number with ‘X’ suffix)
5. Start the tool and allow it to continuously tighten the fastener.
Full torque will only be applied when the motor stalls.
6. Stop tool and remove from fastener.
Manual Two Speed (Part Number “*****.XMTS”)
NOTE:
‘FAST’ speed is for initially running up of the fastener and
‘SLOW’ speed for applying the final torque.
5. Set speed selector to ‘FAST’.
TIP: To change the speed (see Figure 10):
A. Ensure tool is not running.
B. Pull selection knob out.
C. Move knob to required speed setting.
D. Ensure selection knob is fully engaged in recess.
6. Start the tool and allow it to continuously tighten the fastener.
7. When the tool motor stalls, stop the tool.
FIGURE 10 –
’FAST’ speed above,
‘SLOW’ speed below.
Summary of Contents for 16011.X
Page 21: ...20...
