12
Input Ports
The input ports are located at the rear of the tool and covered by plastic protection caps (# 16199).
Connect the air supply to the clockwise (FWD) and anti-clockwise (REV) ½” BSP connectors as shown in
Figure 9.
Exhaust Port
The exhaust port, located on the side of the tool, is common to both inlet ports.
TIP: As with any pneumatic tool a fine oil mist is present in the exhaust air.
Please ensure the exhaust air cannot cause a hazard.
Inlet Ports
REV
FWD
Air Motor
Housing
Air Exhaust
Silencer
Output Square
Drive
FIGURE 9 –
Tool features
Summary of Contents for 16011.X
Page 21: ...20...
