3. To ensure a maximum protection it is most important that the seat belt is correctly used and tightened
on the seat as firmly as possible.
4. Do not add or modify this product in any way.
5. Never use this product if it has been in an accident or if it has become badly worn.
6. Do not leave a child unsupervised in the seat at any time.
7. Ensure that no part of the seat or seat belt is trapped in a door or a folding seat. If your car has a
folding rear seat ensure that it is correctly latched in its upright position.
8. Car interiors can become very hot if the car is standing in direct sunlight. Therefore it is recommended
to cover the child seat by a towel or something else to prevent the child seat becoming hot and burning
the child.
9. The safety belt buckle is not fully tamper proof and therefore your child should never play with it.
10. Luggage and other heavy objects should be secured in the car boot. Loose objects are liable to cause
injury in the event of an accident.
11. The child seat must not be used without the cover and the cover should not be replaced with any other
cover than one supplied by the manufacturer of this seat.
12. The manufacturer only guarantees the seat if this is used according to the regulations.
13. In an emergency your child can be released quickly by pressing the red button on the seat belt buckle.
14. Store this child seat in a safe place when it is not being used. Avoid placing heavy objects on it.
15. If you travel with passengers using both the front and rear passenger seats note that the lighter
occupants should be in the rear and the heavier occupants in the front of the vehicle.
If you are in doubt consult either the child restraint manufacturer or the retailer.
FITTING THE BOOSTER CUSHION
Step 1: Place the child seat on the seat ensuring it is firmly against the vehicle seat.
Step 2: Sit your child on the child car seat with their back against the backrest. Place the seat belt around
your child positioning the lap section of the safety belt under both armrests. Insert the buckle tongue in the
belt buckle and pull the lap belt tight. Thread the diagonal belt under the armrest on the buckle side only.
Pull the diagonal belt tight. Ensure that the belts are tight and not twisted.Ensure that the lap belt is low to
held the pelvis.
Step 3: To release your child from the child car seat release the belt buckle and remove your child from
the child seat carefully.
When the child car seat is not in use always secure it by placing
the seat belt around it.
Ensure that the belts are routed according following picture (red marking).
The fabric cover can be easily removed for washing 30° C and have to be air dry.
The harness and plastic parts can be sponged with very mild detergent and warm water. Do not use
chemical cleaner and bleach or corrosives on any part of the seat.
Only if the belt is suitable.
NOTICE
This is a „Universal“ child restraint. It is approved to Regulation
No. 44, 04 series of amendments, for general use in vehicles
and it will fit most, but not all, car seats.
A correct fit is likely if the vehicle manufacturer has declared in
the vehicle handbook that the vehicle is capable of accepting a
„Universal“ child restraint for this age group.
This child restraint has been classified as „Universal“ under
more stringent conditions than those which applied to earlier
designs which do not carry this notice.
If in doubt, consult either the child restraint manufacturer or the
retailer.