10
5
ELECTRICAL INSTALLATION
Figure 8 – Cable Connections
Cable C01 and C02 are the only
cables included in the kit.
1.
Locate the end of the previously
installed valve extension cable. This is
at the rear of the sprayer.
2.
Disconnect the Case Interface Cable
from the Valve Extension Cable and
connect
cable
C02
between
the
connectors.
3.
Connect the Valve Extension Cable and
the Case Interface cable to the
appropriate connections on cable
C02
.
4.
Connect the three pin tower on cable
C02
to the free three pin shroud on the
valve extension cable.
5.
Connect cable
C01
to the three pin
shroud on cable
C02
.
6.
Connect the 2-pin connector on cable
C01
marked
ROLL CW
to the coil on
the port side of the valve block.
The port side is the side of the
valve block with the left and right
tilt hoses.
7.
Connect the 2-pin connector on cable
C01
marked
ROLL CCW
to the other
free coil.
The pigtails on cable C01 are not
used for this installation.
8.
Tie up all cabling so that it will not
interfere with any components on the
sprayer.
