14
4.5
R
OLL
S
ENSOR
I
NSTALLATION
Mount the roll sensors to the included roll
sensor brackets using the machine screws
and nylon lock nuts, as illustrated in
Figure
16
.
The roll sensors must be
mounted tightly to the brackets.
Figure 16: Mounting the Roll Sensor
to the Roll Sensor Mounting Bracket
When mounting the roll sensors, use the
following guidelines and refer to
Figure 17
.
a)
The intermediate frame roll sensor
must have the lowest serial number and
the chassis roll sensor must have the
highest serial number.
b)
The smaller the distance between
A
and
B
in
Figure 17
, the better the
performance will be.
c)
Ensure the roll sensors are sitting
relatively level when the sprayer chassis
and boom are level.
d)
All roll sensors must be mounted with
the circular AMP connector facing
towards the Right-Hand Wing (when
looking from the rear of the sprayer).
Figure 17: General Roll Sensor Mounting Location on a Trapeze Style Boom
Connectors towards
Right-hand Wing
Summary of Contents for UC4+ Apache 1010 2005+
