7
NookBox
Installation Guide
Repeater
Walk Test Mode
Learnt-in Control Panel or learnt-in devices can check for its signal range with the Repeater if the Repeater enters Walk Test Mode.
Step 1
Under Normal Mode, slide DIP Switch 2 to the On position. The Repeater will emit 1 long beep and the Yellow LED will flash
(1 flash every second).
Step 2
When the Repeater receives signals from the Control Panel or the learnt-in devices, it will emit a long beep and the Blue LED
will light up for 1 second. The signal is then retransmitted as the Red LED lights up for 1 second.
Step 3
To exit Walk Test Mode, slide DIP Switch 2 to the Off position. The Repeater will emit 1 long beep and the Yellow LED will turn off
Clear Mode (Factory Reset)
Clear the previously programmed memory and reset the Repeater to Factory Default
Step 1
Under Normal Mode, slide DIP Switch 3 to the On position. The Repeater will emit 1 long beep and the Yellow LED will light up.
Step 2
Press and hold the Test button for 5 seconds. The Repeater will emit 1 long beep to indicate all learnt-in devices and Control Panel
are cleared from the Repeater.
Step 3
To exit Clear Mode, slide DIP Switch 3 to the Off position. The Repeater will emit 1 long beep and the Yellow LED will turn off.
Operation
If the Repeater receives a signal from the Control Panel (e.g. a command), the signal is retransmitted to the corresponding device(s)
from the Repeater. The transmission LEDs will light up accordingly.
If the Repeater receives signal from a device (e.g. an alarm signal), the signal is retransmitted to the Control Panel from the Repeater.
The transmission LEDs will light up accordingly.
