4
NookBox
Installation Guide
Repeater
Power Supply
A Power Adapter is required to connect to a wall power outlet. Be sure only to use an adapter with the appropriate AC voltage
rating to prevent component damage. A DC 12V 1A output Power Adapter is generally used to power the Repeater.
Power Adapter Application:
To connect the Power Adapter:
Step 1
Locate the Power Adapter and plug into the DC power jack.
Step 2
Plug the Power Adapter to a wall power outlet.
Step 3
The Repeater will sound a Long beep and the Green LED will light up.
AC Failure/AC Restore:
The Repeater will send an AC Failure signal to the Control Panel when the Power Adapter is unplugged for 30-60 seconds.
When the Power Adapter is plugged in again for 30-60 seconds, the Repeater will send an AC Restore signal to the Control Panel.
Rechargeable Battery:
In addition to the adapter, there is a rechargeable battery inside the Repeater, which serves as a back-up power in case of a power failure.
When the Power Adapter is plugged into the DC power jack, slide the Power Switch to the ON position so the Power Adapter supplies power
to the Repeater and at the same time recharges the battery. It takes approximately 72 hours to fully charge the battery.
When the Power Adapter is unplugged, the Repeater will be powered by the rechargeable battery.
The Repeater can detect the battery voltage. When the battery voltage is low, the Green LED will flash to indicate low battery status.
