6
NookBox
Installation Guide
Repeater
Learn into Control Panel
Step 1
To learn the Repeater into the Control Panel, slide DIP Switch 4 to the On position under Normal Mode.
The Repeater will emit 1 long beep and the Yellow LED will turn on.
Step 2
Put the Control Panel into Learning Mode (please refer to the Control Panel manual).
Step 3
Press the Test button. The Repeater will transmit a Test Code to the Control Panel as the Red LED lights up and the
Repeater emits 1 beep.
Step 4
If the Repeater receives an acknowledge signal from the Control Panel within 60 seconds, Learning is successful.
The Blue LED will light up for 1 second as the Repeater emits 1 long beep.
If the Repeater fails to receive an acknowledge signal from the Control Panel within 60 seconds,
learning has failed and is indicated by the Yellow LED flashing 3 times. Please repeat step 3-4 again.
Step 5 Slide DIP Switch 4 to the Off position. The Repeater will emit 1 long beep and the Yellow LED will turn off as the
Repeater returns to Normal Mode.
Learning Repeater into Repeater
If Repeater A is learning into Repeater B:
Step 1
Putting Repeater B into learning mode: Under Normal Mode, slide DIP Switch 1 of Repeater B to the On position.
Repeater B will emit 1 long beep and the Yellow LED will flash slowly (1 flash every 2 seconds).
Step 2
Press the Test Button on Repeater A to send a learn code. Repeater A will emit 1 beep and the Red LED will turn on.
If Repeater B receives the learn code from Repeater A, it will emit 1 long beep and the Blue LED will light up for 1 second
to indicate successful learning.
If Repeater B receives the learn code from Repeater A and Repeater A was already learnt, Repeater B will emit 2 beeps and
the Blue LED will light up for 1 second.
<NOTE>
•
Please do not cross-learn the Repeaters, e.g. Learning Repeater A into Repeater B and learning Repeater B into Repeater A.
•
All repeaters will have to be learnt into the Control Panel.
Step 3
When the learning is complete, slide DIP Switch 1 of Repeater B to the Off position. Repeater B will emit 1 long beep
and the Yellow LED will turn off as Repeater B returns to Normal Mode.
Learning Device into Repeater
Step 1
Under Normal Mode, slide DIP Switch 1 to the On position. The Repeater will emit 1 long beep and the Yellow LED
will flash slowly (1 flash every 2 seconds).
Step 2
Please refer to the device manuals on how to send learn code from the devices
(usually a Test or Learn button is pressed on the devices).
If the Repeater receives a learn code from a new device, it will emit 1 long beep and the Blue LED will light up for 1 second
to indicate successful learning.
If the Repeater receives a learn code from a device already learnt into the Repeater, it will emit 2 beeps and the Blue LED
will light up for 1 second.
A maximum of 60 devices can be learnt into the Repeater. If the user attempts to learn in a 61st device,
the Repeater will emit 4 beeps.
<NOTE>
•
If multiple repeaters are used, please only learn devices into the Repeater(s) closest to the operation areas of the devices.
•
All the devices learnt into the Repeater must also be learnt into the Control Panel.
Step 3
When the learning is complete, slide DIP Switch 1 to the Off position. The Repeater will emit 1 long beep,
the Yellow LED will turn off as the Repeater returns to Normal Mode.
