GB 30
Parental Ctrl
To open this menu you will be asked to enter your access code.
From the factory the access code is set to 1234
.
The following settings can be altered from this menu.
Access Control
Select “Yes” or “No” to turn the access control in all menus on
or off. Note: When “No” is selected, the access code does not
have to be entered to watch locked channels.
Receiver lock
If you select “Yes” you will have to enter the access code every
time you start the Mediamaster from standby.
Age rating control
If you want everybody to have access to all available types of pro-
grammes, select “No”
If you select “Yes” you may block programmes unsuitable for chil-
dren.
Age Limit
Select an age limit between 3 and 18 years on the line that ap-
pears.
However, you should be aware that not all Service Providers have
the necessary codes for these functions implemented in their
transmissions.
Change access code
From here you can change the access code from the stand-
ard 1234. DO NOT FORGET IT! Without it, you do not have
access to any of the functions where the code is required!
Modem Setting
To open this menu you will be asked to enter your access code.
From the factory the access code is set to 1234
.
The Mediamaster is equipped with a built in telephone modem.
Via the modem so called “interactive services”, such as e.g. or-
dering movies, can be performed. To connect the Mediamaster
to the telephone line, please refer to page 14.
You will get information concerning this service by your service
provider. More information may also be available in the “System
information” menu, ref. to page 31.
When configurating the modem, the following parameters have
to be set.
Country
: Select the country where your Mediamaster is installed.
Pulse or Tone
: Select the alternative valid for your telephone line.
If in doubt, please contact your phone operator.
Prefix
: If the connection has to pass a switch board, enter the
digits that will open the line.
>>>>>>>>>
NAVIBARS
