21.
Multicast VLAN Registration (MVR)
MN700004 Rev 01
262
Example
See the examples below.
no mvr
The
no
mvr
command, in Interface Configuration mode, removes the MVR configuration
from the specified port.
Command Syntax
device-name
(config-if
UU/SS/PP
)#
no mvr
Examples
1. The following example shows how to configure port 1/1/1 as an MVR receiver port:
device-name
(config)#
interface 1/1/1
device-name
(config-if 1/1/1)#
mvr type receiver
2. The following example shows how to configure Ethernet port 1/1/1 as an MVR source
port:
device-name
(config)#
interface 1/1/1
device-name
(config-if 1/1/1)#
mvr type source
3. The following example shows how to remove port 1/1/1 as an MVR port:
device-name
(config)#
interface 1/1/1
device-name
(config-if 1/1/1)#
no mvr group
MVR Show Commands
Table 21-3 summarizes the MVR show commands.
Table 21-3 MVR Show Commands
C o m m a n d D e s c r i p t i o n
show mvr
Displays configured MVR parameters with regard to the switch.
show mvr interface
Lists the current MVR configurations and status per MVR ports.
show mvr members
Lists the current MVR configurations and status per MVR groups.
show mvr
The
show mvr
command, in Privileged (Enable) mode, displays the following information,
with regard to the switch:
•
MVR status (enabled or disabled)