16
Usage
The base station will not require any continuous operations or actual use from the user. The device
works independently and will not usually require operations after installation. However, from time to
time, check that the device is still functional.
Multifunction button
In normal mode, LED bar indicates GSM signal strength. Short press of multifunction button sets the
LED bar indicates the RAM buffer consumption. Second short press sets the LED bar indicates FLASH
memory consumption. Third press return the LED bar to indicates GSM signal strength. See below
LED F1.
Long press sets the device to firmware OTA update mode. See below LED F2.
If the battery low alarm sound, it can be acknowledged by a short press. See below LED BAT.
LEDs
GSM
Blinks green
GSM-modem is starting up.
Blinks yellow
There is no SIM-card in place.
Solid green
GSM-modem has 3G connection.
Solid yellow
GSM-modem has 2G connection.
Blinks red
GSM-modem replies: Registration denied.
Solid red
GSM-modem is unable to communicate with the internal processor.
SRV
Off
When there is no IP-address.
Blinks yellow
When it tries to connect to Ovaport.
Blinks green
When in connection to Ovaport and tries to "shake hand".
Solid green
When in connection to Ovaport and handshake is successful.
RF1
Blinks green about every 10 s Received a packet from the MTR network (433,92 MHz) within 1 min
30 s.
Solid yellow
There are packets in the flash buffer that hasn't been send to
Ovaport (also blinks green every 10 s if new packets arrive).
Solid red
Flash buffer is full (also blinks green every 10 s if new packets arrive).
RF2
Blinks green about every 10 s Received a packet from the Ovanet network (2,4 GHz) within 1 min
30 s.
Off
No neighbours found at Ovanet network.
Blinks yellow about every 10 s When it has neighbours (transit to blink green, once it gets
measurement packets).
Solid red
When Wirepass (Ovanet) signals an error or internal processor can't
communicate with the Wirepass (Ovanet) processor.
