5
than the rated capacity
(8) When forks is bearing load,tilt backwards mast mostly,the yoke should always contact with
load;lift forks upto 200mm high from ground before driving
(9) No standing under forks,no standing on forks when lifting
(10) The starting speed should not be too fast when starting to lift and lower the load
(11) No operation of truck and it’s additions without sitting on the driver’s seat
(12) Push handle immediately to middle position when the mast has tilted forward or
backward to the extreme position
(13) No driving or turning when the mast is lifting
(14) When travelling,pay attention to passers by,obstacles,irregular road and the clearance of
upper side of forklift
(15) Be careful of travelling on slope,when the angle of slope is more than10%,travel forward
upslope and travel backward downslope. no turning on slope,no loading or unloading when
travelling downslope
（
16
）
Reduce speed when turning on the damp or slick road,take special care and drive slowly
when travelling on dock or on temporary board
(17) Operating high lift range truck of which the lifting height is more than 3m,pay attention to
the dropping of the load,and take measures to prevent it when necessary
(18) Don’t convey unfastened or loosely stacked load,be caref when conveying large-size
load
(19) When travelling with load,avoid emergency brake
(20) When leaving the truck,lower the forks to ground;push lever to free position,switch off
power,when parking on the slope,pull tight the brake apparatus and plug the wheels with wedge if
the parking time is long
(21) The protection valves on multiway valve and on steering device are already regulated,so
the users shouldn’t regulate randomly when using to prevent that the excessively high oil pressure
leads to the damage of the whole hydraulic system and the burnout of the electric motor
(22) Charge the tyres according to the pressure value stated in “tire pressure” indication
(23) Treat the operation of non-load truck with additional apparatus as the operation load
truck
5. Battery charging
(1) In the first time of charging or boost charging of battery,act strictly according to the rules
stated in battery specification
(2) When the truck is in working,and when the battery voltage drops to 41V or any one of the
cells voltage drops to 1.7V or the meter alarms,stop working immediately,charge the battery or
change another fully charged battery
(3) Inspect at any moment the density,the level and the temperature of electrolyte when
charge the battery
(4) Charge the battery at once after use of the truck,the storage period should be less than
24h;in order not to damage the battery,prevent under charging or over charging of the battery
(5) In order to adjust the density of each cell,make a equalizing charge of the battery in
regular service once a month,please refer to the related chapter to get the details of the charging
method and usage maintenance
