Wrong cable specification.
• Joystick operates colour and gobos instead of beam
position
DIL switches on lantern set incorrectly (it is likely that switch
#2 is on when it should be off)
• Microbeam, Datamoon or IQ250 gobos cannot be
selected separately
It is not possible to select gobos separately on these products
• Other manufacturers' products do not operate
correctly
The IQ-MX80 is only intended to operate NJD lanterns
*A fault in the cable may affect lanterns anywhere in the DMX
chain, not necessaraily those adjacent to the fault.
Technical specification.
Dimensions:
482 × 133 × 100 mm
Power supply:
230V AC 50Hz
Power requirements:
9VA
Mains input:
IEC connector
Fuse:
F250mA 5 × 20mm HBC to IEC127.
(located inside mains input connector)
Sound input:
¼” mono jack
0.775V to 60V rms (0 to +40dBm)
Impedance:
15k
W
DMX output:
3-pin female XLR
Data+ = pin 2
Data- = pin 3
Earth = pin 1
Channels
1-128
Standards:
The IQ-MX80 complies with the following standards:
EN60950 electrical safety
EN55103 electromagnetic compatibility
EN60297 fascia panel dimensions
RS-485 Digital transmission system
USITT DMX512 Lighting control protocol
© N.J.D. Electronics 1997
-Page 11-
User Guide
IQ-MX80
