11
(5) Storage
●
When storing Cutting Oil after use, put it into a
container and put a lid on for tight sealing so
that dust or moisture, which is a catalyst for
contamination, may not get in.
●
Avoid direct sunlight, rainwater or the like and store
Cutting Oil in a dim cool area.
(6) Disposal
●
For disposal of concentrate solution and used
fl
uid,
request a waste-disposal company to dispose them
as industrial waste in accordance with the local laws
and regulations.
●
Treat flushing water through pH adjustment,
condensation/sedimentation, activated sludge
process, activated carbon adsorption, etc., and
discharge it in accordance with the regulations of
your local municipal bylaw.
●
Residual dross will remain in an emptied container:
be careful when handling an empty container.
(7) Others
●
When Cutting Oil is poured into another container
for use, post chemical and label information at the
site where it is kept. At the same time, keep the
Operation Manual handy so that it can be referred to
whenever necessary.
●
For further details, contact us for product safety data
sheet.
●
All the information and descriptions that have been
provided are based on the currently available
documents and information, which may be revised
upon our new recognition and/or discovery.
●
The precautions provided apply to regular handling.
If special handling method is used, take safety
measures that are suitable for your applications and
usage.
●
The information contained herein is for your
reference purpose only, to which we make no
warranty of any kind and for which we shall not be
held responsible.
Preparation of Cutting Oil
(1-1)
Use our genuine-product Cutting Oil (blue).
If other Cutting Oil is used, the cutting
performance and service life of cutter would be
decreased.
(1-2)
Use tap water to dilute Cutting Oil by 8- to
10-fold. Do not use well water.
(1-3)
The oil tank is of the stationary type.
Remove the rubber cap and pour Cutting Oil
from the Oil Tank inlet. Do not spill Cutting Oil
on the machine.
5-6. Connecting the Power Supply Plug to Power
Source
●
Before connecting the power supply plug to power
source, turn off the switch.
Always use the correct voltage for power source.
6. MACHINE OPERATION
WARNING
●
Always Wear Safety Glasses.
●
Always Wear Hearing Protection.
●
Wear respiratory protective equipment.
●
Never touch the mounted cutter and the rotating
parts of the machine such as the Spindle Arbor
after the power cable is connected to power
source.
CAUTION
●
Do not use hard material such as a screwdriver,
to operate the Motor Switch. This may damage
the panel and switch, which would lead to
machine failure.
6-1 Start and Stop
(1) Magnet On
Set the Magnet Switch to On the Magnet will
activate.
(Fig. 14)
MAGNET
push
Fig. 14
(2) Drill Motor On
Set the Motor Switch to On . The Drill Motor will
start.(Fig. 15)
MOTOR
push
Fig. 15
(3) All Stop
When the Motor Switch is set to off, the Motor
will stop. When the Magnet Switch is set to the
Off position, the magnet will be deactivated and all
functions will stop.
Summary of Contents for ATRA ACE WA-3500
Page 9: ...8 3 PART NAME Fig 8...
