Nimbus Water Systems WIMI6200, User Manual, Page: 67 / 72

WiMi6200 User’s Manual
3.6 Operation of USB port
The USB port operation is applied to both WiMi6200T and WiMi6200R
 IP configuration of the WiMi6200T and WiMi6200R through the USB port

Create both a config.tx and a config.rx files on the root directory of the USB
memory stick.
 The config.tx file must include below text
FACTORY_DEFAULT=YES : This line must be located at first line of the file.
ipaddr=192.168.0.161 : IP address of the WiMi6200T
netmask=255.255.255.0 : Sub-net Mask of the WiMi6200T
gatewayip=192.168.0.1 : Gateway IP address of the WiMi6200T
PEER_IP=192.168.0.162 : IP address of the peer device (WiMi6200R)
# Comments of the above configurations
 The config.rx file must include below text
FACTORY_DEFAULT=YES : This line must be located at first line of the file
ipaddr=192.168.0.162 : IP address of the WiMi6200R
netmask=255.255.255.0 : Sub-net Mask of the WiMi6200R
gatewayip=192.168.0.1 : Gateway IP address of the WiMi6200R
PEER_IP=192.168.0.161 : IP address of the peer device (WiMi6200T)

Insert the USB memory into the USB port of the WiMi6200T, and recycle the
power.
 Wait for 3~4 seconds until the LED stops the fast blinking, and after stop fast
blinking the USB memory
must be removed from the WiMi6200T/R.
Note: The USB memory must be removed from the WiMi6200T/R once the fast
blinking of LEDs stops
.
Note: The character “#” in the beginning of the line will ignore the rest of text on the
same line.
Note: If there is only “FACTORY_DEFAULT=YES” in the file, then it will work as the
factory reset operation.
Distributed by Pera Systems, Inc. Page 66 v1.2