Nimbus Water Systems WIMI6200, User Manual, Page: 55 / 72

WiMi6200 User’s Manual
2 Ethernet NetMask R/W Subnet mask of the decoder IP address
3 Ethernet MAC R Mac Address
4 Ethernet Gateway R/W Gateway of Sub-network
5 Streaming Mode R/W
P2P: Point to point mode. Streaming from Ethernet IP
A
○
1
E
A
to Peer
IP
⑧
Multicast: Point to multi-point mode, Streaming from one TX to
many RXs with the multicast address
⑦
.
6 Streaming I/F R Selection of streaming interface: Ethernet LAN
7
Wi-Fi RXID
(multicast)
R
Current receiver ID selected on the front panel of the
WiMi6200R. There can be maximum 4 receivers for one
transmitter when the system is operating in Wi-Fi mode. This
Wi-Fi RXID is used to identify specific RX from the TX. The one
value must be assigned to the only one receiver in one Wi-Fi
network with same SSID.
8 Wi-Fi SSID R
Current SSID selected on the front panel of the WIMi6200R.
This value must be same with the SSID of the WiMi6200T.
9 Wi-Fi Quality R Wi-Fi signal strength received at this WiMi6200RW
10 Group IP R/W
Multicast IP address used for receiving A/V data from the
WiMi6200T. Default multicast IP address is 227.2.2.7.
11 Peer IP(lan) R/W
IP Address of peer encoder. Default & factory setting IP address
of the encoder is 192.168.0.161.
12 Peer Machine R
The status of the peer machine, such as P2P or Multicast ,and
its IP address
13 Peer S/W version R The software version of the peer encoder machine
14 Local Machine R The status of the local machine, such as P2P or Multicast
15 Local S/W version R The software version of the local machine, WiMi6200R
16 Submit W
All the values on this web page will be written to the system
when this button is clicked.
17 Refresh R
All the values of the system on this web page will be read from
the system and displayed when this button is clicked.
Distributed by Pera Systems, Inc. Page 54 v1.2