ee System r
t o
228
Ser
e
S
Front Driving Wheel Armature Disassembly/Assembly (Continues)
Assembly
11.
$VVHPEOHWKHFRPSRQHQWVLQWKHUHYHUVHRUGHURIGLVDVVHPEO\DQGQRWHWKHIROORZLQJ
Remove any dust or debris from the stator and removed components.
Lubricate with grease the grommet lips (P) before reassembling the armature (N).
Check that the bearings of the armature (N) are properly installed on the shaft.
To ease the installation of the carbon brush cap assembly (J) unscrew the caps and temporarily re-
move the carbon brushes (refer to the procedure “Drive System Motor Carbon Brush Check/Replace-
ment” in the relevant paragraph).
Assemble the carbon brush cap assembly (J) with the reference mark (E) matching the position
marked during the removal procedure.
Tighten the fastening screws (H) of the carbon brush cap (J) at 5.5 Nm.
Tighten the fastening screws (A) of the left bracket (C) at 22 Nm.
12. Check the proper operation of the driving wheel.
13. Reassemble the driving wheel and steering assembly (see the procedure in the previous paragraph).
H
J
P
N
A
C
E
P200265
Summary of Contents for SW4000
Page 233: ......
