Nilfisk-Advance Condor XL, Service Manual

Page: 231 / 233

:KHHO6\VWHP7UDFWLRQ 6HUYLFH0DQXDO±$GYDQFH&RQGRUŒ;/1LO¿VN(5
7UDFWLRQ'ULRVH5RXWLQJ
If the traction drive motor or the
Hydraulic Hoses
to the motor are replaced or repaired, it’s important to
route the
Hydraulic Hoses
correctly when reinstalled to prevent wear or damage to the
Hydraulic Hoses
and
surrounding components.
When reinstalling the traction drive motor
Hydraulic Hoses
:
1. Install the
Hydraulic Hoses
EXWOHDYHWKHÀWWLQJVORRVHRQ
both ends so the
Hydraulic Hoses
can pivot.
2. Turn the steering wheel all the way toward the left. The
ÀWWLQJVVKRXOGEHRQWKHIURQWVLGHRIWKHPRWRU
3. Make sure the
Hydraulic Hoses
are routed up and inside
the channel in the
Drive Wheel Weldment
as shown on
WKHULJKWDQGOLHÁDWDJDLQVWWKH
Bottom of the Frame
as
shown below.
4. Make sure the
Hydraulic Hoses
are not twisted, then
WLJKWHQWKHÀWWLQJVRQERWKHQGVWRIWOEV1RWHWKDW
WKHÀWWLQJVPXVWEHWLJKWWRSUHYHQWORRVHQLQJZKLOH
steering.
5. Turn the steering wheel all the way toward the left and
right several times to make sure the
Hydraulic Hoses
don’t catch and are not rubbing against the surrounding
components.
Hydraulic
Hoses
Drive Wheel
Weldment
Bottom of
the Frame
Hydraulic
Hoses