Nilfisk-Advance condor BR 1100S series, Instructions For Use Manual

Page: 25 / 56

ENGLISH / A-25
FORM NO. 56041633 - Condor™ / BR 1100S series - A-25
GENERAL MACHINE TROUBLESHOOTING
Problem Possible Cause Remedy
Poor water pick-up Worn or torn squeegee blades Reverse or replace
Squeegee out of adjustment Adjust so blades touch fl oor evenly
across entire width
Recovery tank full Empty recovery tank
Recovery tank drain hose leak Secure drain hose cap or replace
Recovery tank cover gasket leak Replace gasket / Seat cover properly
Debris caught in squeegee Clean squeegee tool
Vacuum hose clogged Remove debris
Using too much solution Reduce fl ow via control panel solution button
Foam fi lter cover not seated Seat cover properly
Poor scrubbing performance Worn brush or pad Rotate or replace brushes
Wrong brush or pad type Consult Nil fi sk-Advance
Wrong cleaning chemical Consult Nil fi sk-Advance
Moving machine too fast Slow down
Not using enough solution Increase fl ow via control panel solution button
Scrub Motors Do Not Run Tripped 20 Amp (F3) circuit breaker Check for electrical short circuit & reset
Inadequate solution fl ow
or no solution
Solution tank empty Fill solution tank
Solution lines, valves, fi lter or trough clogged Flush lines, trough and clean solution fi lter
Solution turned OFF Activate fl ow via control panel solution button
Solution solenoid valve plugged or defective
Clean or replace valve (see service manual)
Machine does not run Emergency stop switch tripped Reconnect battery connectors
Operator seat safety switch Check for open circuit and replace
Main system controller Check error fault codes
(see service manual)
Tripped 3 Amp (F1) circuit breaker Check for electrical short circuit & reset
No FWD/REV wheel drive Drive system speed contoller Check error fault codes
(see service manual)
Emergency stop switch tripped Reconnect battery connectors
Vacuum shuts off and display shows
“FULL” when recovery tank is not full Plugged squeegee hose Clear debris
Vacuuming large amounts of water
at a high travel speed Slow down or disable auto shut-off feature
(see service manual)
Poor Sweeping Performance
(Cylindrical System) Hopper Full Empty and clean hopper
Brushes worn Replace brushes
Bristles have taken a set Rotate brushes
No Detergent Flow (AXP models only) Empty detergent cartridge Fill detergent cartridge
Plugged or kinked detergent fl ow line Purge system, straighten lines to
remove any kinks
Dry seal cap on detergent cartridge not sealed Reseat dry seal cap
Detergent pump wiring
disconnected or backwards Connect or reconnect wiring
revised 3/06