Nilfisk-Advance condor BR 1100S series, Instructions For Use Manual

Page: 14 / 56

A-14 / ENGLISH
A-14 - FORM NO. 56041633 - Condor™ / BR 1100S series
DETERGENT (AXP™ / EDS™) SYSTEM PREPARATION AND USE
Fill the detergent cartridge with a maximum of 2.2 gallons (8.32 Liters) of detergent. SERVICE NOTE: Remove the detergent cartridge from the detergent box prior
to fi lling to avoid spilling detergent on the machine.
See Figure 6. It is recommended that a separate cartridge be used for each detergent you plan to use. The detergent cartridges have a white decal on them so
you can write the detergent name on each cartridge to avoid mixing them up. The detergent cartridge has a Magnetic Slider (AA) on one end that needs to be set
to the proper dilution ratio according to the dilution instructions on the manufacturer’s bottle. Slide the Magnet Slider (AA) to the appropriate location on Detergent
Dilution Ratio Decal (BB) . The system should be purged of previous detergent when switching to a different detergent. SERVICE NOTE: Move machine over
fl oor drain before purging because a small amount of detergent will be dispensed in the process.
To Purge When Changing Chemicals:
1 Disconnect and remove the detergent cartridge.
2 See Figure 7. Turn the Key Switch (A) ON and press the Detergent Switch (J) and the Solution Switch (F) down for at least 2 seconds. NOTE: Once
activated the purge process takes 10 seconds. See illustration on next page for Detergent System indicators. Normally one purge cycle is adequate to purge
the system.
To Purge Weekly:
1 Disconnect and remove the detergent cartridge. Install and connect a Cartridge fi lled with clean water.
2 Turn the Key Switch (A) ON and press the Detergent Switch (J) and the Solution Switch (F) down for at least 2 seconds. NOTE: Once activated the purge
process takes 10 seconds. See illustration on next page for Detergent System indicators. Normally one purge cycle is adequate to purge the system.
FIGURE 6
revised 3/06