8
- FORM NO. 56041258 / Aquamatic Selectric
™
_____________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________
1
Follow the instructions in the
Preparing the Machine for Use
section of this manual.
2
Slide the Plug Lug halves
(24A
&
24B)
together. Connect the Power Cord
(22)
to the machine at the Power Cord
Connection
(19)
, then plug the Power Cord into a properly grounded outlet.
3
Make sure the Solution Fill Cover
(9)
and the Recovery Tank Cover
(8)
are firmly in place and the Solution Valve Lever
(13)
is in the ON position.
4
Turn the Main Switch (
25)
ON. The Solution Button
(4)
will light up to indicate that the solution is ON.
5
Put the Brush Pedal
(21)
UP to lower the brush to the floor.
6
Step DOWN on the Drive Pedal
(20)
and push the pedal to the right to engage the drive motor.
7
Pull and hold the Drive Levers
(26)
UP to propel the machine. To adjust the travel speed, press the Increase Speed
Button
(5)
or the Decrease Speed Button
(2)
. To move backward, hold down the Reverse Button
(1)
while pulling the
Drive Levers; release the Reverse Button to move forward again.
Note:
There will be a slight pause between direction changes.
8
Solution is dispensed only while moving forward
and automatically shuts off in reverse. Press the Solution Button
(4)
to stop solution flow; the light will turn off.
9
Watch the fluid entering the recovery tank cover
(8)
. If there is a large amount of suds in the recovery tank, add a
defoamer chemical to the recovery tank.
CAUTION!
Empty the recovery tank before the fluid or foam enters the Vacuum Hose
(7)
on the right side of the recovery tank
cover.
If there is little or no fluid entering the recovery tank, look to the clear solution hose on the right side of the machine.
If there is no fluid running through the solution hose, the solution tank may be empty. Refill the solution tank with water
and the proper ratio of cleaning chemical.
10
The recovery tank has an automatic float shut-off to block the vacuum system when the recovery tank is full. You can
tell when the float closes by the sudden change in the sound of the vacuum motor. When the float closes, the recovery
tank must be emptied. The machine
will not
pick up water with the float closed.
_____________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________
USING ATTACHMENTS
To use accessory tools, attach the accessory recovery hose to the left port of the recovery tank cover. Attach the
accessory solution hose to the Accessory Connection
(14)
. Connect the other ends of the hoses to the accessory tool.
When using accessory tools, step DOWN on the Brush Pedal
(18)
to raise the brush.
See your Advance Distributor for accessories that may be used with the
Selectric
including:
•
56249360 Liquidator
•
56204223 Drag Tool SS 4 Ft
•
56204224 Hand Tool SS
•
56249318 Scrub & Vac Hose 15 Ft
•
56801000 Aqua Kit (Includes PN 56800385, 56800390 & 56249318)
•
56800390 Drag Tool (Plastic)
•
56800385 Hand Tool (Plastic)
OPERATING THE MACHINE
revised 10/00
