Nilfisk-Advance 13300113, User Manual

Page: 126 / 214

ENGLISH
USER MANUAL
10 33018305(3)2010-01 A RS 851
Consultation of B_BOX • (7, Fig. J), where all the
alarms occurred after the last memory reset are stored.
The alarm is identi
fi ed by a number code that can be
displayed as shown below: repeatedly press the upper
part of the push-button (15, Fig. D) until “MAIN MENU”
appears. Con
fi rm by pressing the lower part of the
push-button (15, Fig. D). The arrow cursor (6, Fig. J)
will be placed near the word “STATUS”. Press the lower
part of the push-button (15, Fig. D) again to bring the
arrow cursor near the word “MAINTENANCE”. Con
fi rm
by pressing the upper part of the push-button (15, Fig.
D). On the display (17) the page “MAINT.01” is shown;
when pressing the upper part of the push-button (15)
again, the page “MAINT.02” is shown. When pressing
the lower part of the push-button (15, Fig. D), the
cursor aligns with B_BOX, then enter the B_BOX by
pressing the upper part of the push-button (15). In this
page, the
fi rst series of numbers (8, Fig. J) indicates
the alarm identi fi cation number, while the second series
of numbers (9) indicates the time at which the alarm
occurred. The stored alarms are up to 16 displayed
on four pages, which can be scrolled by pressing the
push-button (15, Fig. D) repeatedly.
CAUTION!
In the B_BOX the alarms are stored one
after the other, so when the alarms are
detected, always check for the time at
which the alarm occurred to have a real
chronology of the alarms.
Combination switch functions:
Headlights off, with mark (35b) at the symbol O –
Running lights on, with mark (35b) at the symbol –
Low beam on, with mark (35b) at the symbol – . When
the combination switch is in this position, the working light
turns on too.
High beam on, with mark (35b) at the symbol
– and
lowered lever (35a)
High beam temporary on, lifting the lever (35a)
–
Right turn signal on, bringing the lever (35a) forward –
Left turn signal on, bringing the lever (35a) backward –
Horn activation, pushing the lever (35a) in the direction –
shown by the arrow (35c)
(See Fig. E)
Serial number plate/technical data/conformity certi fi cation 1.
Cab vents 2.
Ceiling light 3.
Cab air recirculation vents 4.
Climate control knob 5.
Cab air fl ow control knob 6.
Brake fl uid tank (**) 7.
Suction fan/optional equipment lever 8.
High-pressure water gun 9.
Dust control system nozzle valve: 10.
Suction hose (from suction inlet to hopper) •
Rear suction pipe (*) •
Side broom dust control system nozzle valve
11.
3rd broom dust control system nozzle valve 12.
Parking brake lever 13.
Driver’s seat 14.
Cab heater control knob 15.
Diesel engine throttle lever 16.
Driver’s seat forward/backward adjustment lever 17.
Driver’s seat safety belt 18.
Emergency stop push-button 19.
Accessory distributor pressure inlet 20.
Optional (*)
In the machines with right-hand drive, these components (**)
are on the right side of the driver’s seat.