16. Ventilation module
103
16. Ventilation module
Description
The ventilation module controls the central ventilation system via the Niko Home Control installation. The module is
suitable for use with type C systems (mechanical extract ventilation) or type D systems (mechanical supply and extract
ventilation with heat recovery). Connect the ventilation system to the ventilation module as opposed to the three or
four-way switch supplied with the system.
Overview
550-00140
A.
N screw terminals
This is where the neutral conductor is connected (many
ventilation systems do not require this).
B.
Screw terminals 1’-3’
This is where you connect the control wires of the
ventilation unit for the different settings (low (eco),
medium and high).
C.
Sliding contact
The sliding contact is used for connecting the next
module, which means that the bus and the power supply
module are then also interconnected.
D.
CHANNEL LEDs
One LED per channel. The CHANNEL LED lights up in
TEST mode when the output is activated.
E.
Buttons 1-3
These buttons are used for activating an output. The
others will be deactivated. Please remember that the
activation is only temporary as it will be overruled by the
next bus communication.
F.
L screw terminals
This is where each terminal is connected to the common
of the ventilation unit.
G.
ADDRESS button 1
The function of this button is twofold. In addition to the
function described under “E”, this button is also used
while programming the installation to send the unique
address of the module during the addressing phase.
H.
STATUS LED
The STATUS LED lights up in TEST mode when the
module is connected correctly and is functioning
properly. If an error occurs, the LED will blink to indicate
an error code.
A
H
G
D
E
B
A
F
C
