48
7. Switching modules
7. Switching modules
Description
You can use three-fold or six-fold switching modules to connect three or six switching circuits respectively.
Overview
550-00103
550-00106
A.
N screw terminals
This is where the neutral conductor is connected.
B.
Screw terminals 1’-3’
or 1’-6’
This is where you connect the phase wire from the load that is connected to output 1’ up to 3’
or 1’ up to 6’.
C.
Sliding contact
The sliding contact is used for connecting the next module, which means that the bus and the
power supply module are then also interconnected.
D.
CHANNEL LEDs
One LED per channel. The CHANNEL LED lights up in TEST mode when the output is
activated.
E.
Buttons 1-3
or 1-6
These buttons are used for activating or deactivating each individual output. Please remember
that the activation or deactivation is only temporary as it will be overruled by the next bus
communication.
F.
L screw terminals
This is where the phase of the 230 V mains voltage is connected.
G.
ADDRESS button 1
The function of this button is twofold. In addition to the function described under “E”, this
button is also used while programming the installation to send the unique address of the
module during the addressing phase.
H.
STATUS LED
The STATUS LED lights up in TEST mode when the module is connected correctly and is
functioning properly. If an error occurs, the LED will blink to indicate an error code. See
Error
codes on page 51
.
A
H
G
D
E
B
A
F
C
H
G
D
E
A
B
A
A
A
F
C
