Niko 10-286, Product Information, Page: 37 / 48

37 EN
10-286 / 10-386
10-386
Cable diameter Maximum distance
0,5 mm (UTP) 45 m
0,6 mm (bv. TPVF) 65 m
0,8 mm (bv. SVV, TVVF, JYSTY, …) 115 m
Which power supply do I use?
Power supply Max # 10-505 Max #10-520 Max # external units 10-286
10-801 90
(maximum 3 devices in parallel) 60
(maximum 2 devices in parallel) 1
10-801 + 10-805-01 130 130 5
Note:
1. If the external units are called simultaneously, please note that the address of the external units must be set.
2. Contact Niko for larger installations.
Voeding Max # 10-575 Max # 10-576 Max #10-570 Max #10-570, 10-572
of 10-573 Max # external units 10-386
*10-806 10 12 - - 1
**10-801 + 10-805-01 - - 60 - 1
- - 50 - 3
- - 40 - 5
120 60 - - 5
- - - 70 5
* For smaller installations use video splitter 10-821-01.
** For larger installations use video splitter 10-822-01.
Note:
1. If the external units are called simultaneously, please note that the address of the external units must be set.
2. Contact Niko for larger installations.
3.2. Connection and mounting
Step Action TIP
1. Connection • 10-286
Connect the unit according to the wiring diagram (fig. 1).
• 10-386
Connect the unit according to the wiring diagram (fig. 2).
Disconnect all power before installing the internal unit.
Do not connect the device to the mains voltage until
installation has been completed.
2. Installation of flush-mounting
box
Use the cable openings foreseen in the flush-mounting
box to wire the external units.
Tighten the surface-mounting box using 4 (10-286) or 6
(10-386) screws (fig. 3).
• Mount the flush-mounting box completely level with
the wall.
• Place the camera at a 160 to 170 cm height.
(Not included: screws to mount the flush-mounting box)
3. Cabling The 10-286 requires a 3-wired connection, the 10-386
requires a 6-wired connection.
The cabling between the modules (fig. 4).
Keep in mind the maximum distance between the power
supply and the internal or external unit.
4. Connection of a bell push button
(05-540)
Connect the bell push button to the terminals E and P (fig.
1 & fig. 2). Remove the lamp from the bell push button to prevent
the power from being continuously used, making calls no
longer possible.
5. Mounting sealings • Install the included sealing to the front plate. Firstly, cut
the upper sealing into the right size before sealing off
the sides (fig. 5a).
• To prevent condensation, do not seal the bottom of the
front plate.
Cut the included sealing 1 mm shorter than the width of
the front plate; the sealings must be 0.5 mm off the edge
(fig. 5b).