Nihon Bisoh BISOMAC308, Operator'S Manual

Page: 4 / 58

1
Nihon Bisoh Co., Ltd. BISOMAC308 1Phase&3Phase MM2015/9 KH-2015001
0. READ BEFORE USING BISOMAC308 TRACTION HOIST
This Operator’s Manual had been prepared for the safe and proper operation of the
BISOMAC308 Electric Traction Hoist (referred to as “BISOMAC308”). To
understand the usage of the BISOMAC308, please refer to the following explanation
and system compositions. It is operator’s responsibility to be sure that this hoist is
used safely and properly.
1. Power Supply to the equipment must be fitted with
I. Main switch
NOTE:
Main switch with key-lock or Junction Box with key-lock shall be provided.
II. Residual Current Device (or Ground fault circuit interrupter) of 30 mA
III. Overcurrent Protective Device (Automatic fuse Type C)
NOTE:
Check that the specifications of the electrical supply cable match the power
requirement of the platform and will avoid a voltage drop due to cable length.
2. Weather conditions
I. Temperature Range: 14
゜
F (-10
゜
C) and 104
゜
F (+40
゜
C)
II. Contaminants: Degree of protection IP54
III. Altitude: Less than 3,280 ft (1,000 meter)
3. Precautions prior to use
I. Before using the equipment, operators must carry out the Daily Tests and
Inspections described in Section 7 of this manual and make sure that the
equipment is in normal working condition.
BISOMAC308 Traction Hoist
Suspension Wire Rope
Platform
Stirrup
Power Cable