SD210 Series
Operating & Safety Instructions
English/USA – 07/11
Issue 06
16
3.3.3
MONTHLY SAFETY CHECKS
1)
Check the engine oil level (if applicable).
2)
Check the wheel nuts (torque 110ft lbs / 150Nm).
3)
Check that the bolts holding the wheel motors to the chassis are secure.
4)
Check outriggers for condition, security and operation.
5)
Check that the slew worm is secure and correctly in mesh. Clean and re-grease.
6)
Inspect brakes for operation and wear.
7)
Grease the slew gear and worm gear.
8)
Inspect the engine fuel tank for damage or leaks.
9)
Check telescopic boom wear pads and nylon studs (if applicable).
10)
Check and adjust if necessary the Nylatron studs around the telescope boom.
11)
Every
three
months check and verify the calibration of the cage weigh system. See section
4.7.4 for the calibration procedure.
12)
Every
Six
months perform a
thorough examination
in accordance with the ‘Lifting Operation
and Lifting Equipment Regulations’ (LOLER) 1998, Regulation (9)(3)(a).
3.3.4
ANNUAL SAFETY CHECKS
1)
Check that all pivot pins and their swing bolts are secure.
2)
Inspect for any cracks or badly rusted areas on booms and chassis.
3)
Change the hydraulic oil and the oil filters.
4)
Check the bushes in the front wheel hubs for wear.
5)
Check that slew ringbolts are secured (torque 220ft lbs. / 300Nm).
Summary of Contents for SD210 Series
Page 2: ......
