English –
2
EN
PRODUCT OPERATION
3
• Switching On of TTPRO:
press and release the
ON/OFF
button. If it is connected to a
motor/control unit, it immediately displays the functions already programmed and those
available.
• Switching Off of TTPRO:
hold the
ON/OFF
button for a few seconds until it beeps. If
not used, it switches off automatically after 1 minute.
3.1 - Function and description of buttons
BUTTON FUNCTION
DESCRIPTION
OK
OK
Confirms each programming activity.
ON/OFF
Switching on/off of TTPRO and search for con-
nected motor.
OPEN
Sending of Open command
(= Open button on the transmitter).
STOP
Sending of Stop command
(= Stop button on the transmitter).
CLOSE
Sending of Close command or, for the awnings, De-
scent command (= Close button on the transmitter).
+
Increase by a single level (bound by the function
and displayed by the LEDs).
–
Decrease by a single level (bound by the function
and displayed by the LEDs).
DA
Y
CONT
.
AUTO
1
2
Test / Mode / V
alue Set
3
4
5
6
7
8 A
ON
F2
F1
F3
RADIO
TEST
Chrg
ON
RDC
Usb
1
PRODUCT DESCRIPTION AND INTENDED USE
1
The TTPRO programmer is a logical unit designed to simplify the installation, testing and
maintenance of Nice motors and control units. It is compatible with motors/control units
of the ERA/ERA INN series.
WARNING! - Any other use different from that described and in ambient condi
-
tions different from those provided in this manual is to be considered improper
and prohibited!
TTPRO communicates with the motor/control unit via the TTBUS connection and allows
you to quickly and intuitively perform the procedures normally performed with the trans-
mitter. It acts directly on the motor/control unit, where the transmitters and the operation
parameters are stored.
Other functions are available:
- ability to read the configuration of a motor/control unit (parameters and/or transmitters)
and to transfer the configuration to one or more motors/control units.
- ability to copy and transfer the configuration of a group of motors, if these are connected
to the control panel via TTBUS network.
Components and accessories in the package:
• 1 programmer TTPRO
• 1 connection cable to the motor
• 1 micro-USB connection cable
• 2 rechargeable Ni-MH AA batteries
ELECTRICAL CONNECTIONS
2
WARNING!
- The motor/control unit should only be powered as described in the respective
instruction manual.
- TTPRO must be connected to a single motor/control unit. If you want to connect
multiple motors, it is necessary that each motor is associated with a different
address to those used by other motors. Therefore, before connecting them all,
use TTPRO to assign a unique address to each motor/control unit.
Normally, TTPRO works with 2 rechargeable batteries, however, if necessary, it can also be
powered with the included USB cable.
To connect TTPRO to the motor/control unit, use the cable supplied respecting the polarity
markings (
fig. 1
):
-
white-black cable
(COMMON - 0 V) to be connected to the
black wire
of TTPRO
-
white cable
(STEP-BY-STEP + TTBUS) to be connected to the
white wire
of TTPRO
