18
www.hysecurity.com
10.2 - Push to Open Installation
PIVOT ARM INSTALLATION - Location of Pivot Point
Measurements are taken from the center of pivot of the gate hinge.
The pivot arm needs to be securely mounted to the hinge post or equivalent mounting surface. It is recommended to weld the
pivot arm to a metal post. In order to achieve the correct articulation, geometry and rate of speed of the gate it is critical that
the measurements below are followed. The pivot arm may need to be cut to achieve the correct placement of the actuator
mounting hole. Measurements are taken from the center of pivot of the gate hinge.
DIRECTION OF OPENING
GATES CLOSED
HINGE POST
HINGE POST
LEFT HAND SWING
RIGHT HAND SWING
TOP VIEW
6”
11”
6”
11”
FIGURE 10 - 3 PUSH TO OPEN INSTALLATION
10.3 - Actuator mounting
Mount the actuator to the pivot arm as shown.
The lock nut should be snug to prevent movement or shifting
when the actuator is running. This will also prevent excessive
“bounce” or “wobble” when the gate stops moving.
or Pin
with
Clip
FIGURE 10 - 4 ACTUATOR MOUNTING
FIGURE 10 - 5 GATE BRACKET MOUNTING
10 - INSTALLATION PROCEDURES (CONT.)
Summary of Contents for TITAN12L
Page 2: ......
Page 33: ...www hysecurity com 33...
Page 34: ...34 www hysecurity com...
Page 35: ...www hysecurity com 35...
