Nice MhouseKit SL1W, Instructions And Warnings For Installation And Use

Page: 32 / 156

30 – English
English
LED P3 Status Action
Off * All OK “Slow” speed selected
On All OK “Fast” speed selected
1 flash per second The device recognition phase has not been
carried out, or there are errors in the memo-
rized data
Run the recognition phase again (see paragraph 10.3.3 “Adding
further devices to an existing system”).
2 long flashes Devices recognition phase in progress Indicates that it is in the process of recognising the attached de-
vices (this will take a maximum of a few seconds).
STOP LED Status Action
Off * All OK Cycle operation
On All OK Complete cycle operation
OPEN LED Status Action
Short beep + long beep at
the end of the manoeuvre
The automation has just completed a ma-
noeuvre or test phase
Check led P1
Short beep During wireless devices installation phase.
The control unit has learned the new wire-
less device
Normal operation
Short beep Indication resulting from battery insertion into
an accessory device, when the automation
is stopped. The battery has been inserted
into a wireless device known to the network
and the control unit has recognised it
Normal operation
Short beep + long beep Indication resulting from battery insertion
into an accessory device, when the auto-
mation is stopped. The battery has been
inserted into a wireless device known to the
network and the control unit has recognised
it but it is indicating that its battery is
empty
.
Check the charge of the newly inserted battery
Short beep A device has been deleted from the network
Prolonged 6 second beep The procedure described in paragraph
10.3.5 is active, within which you can con-
firm deletion of a wireless network present
in the network.
Normal operation
* or it could be in “Standby” mode