NextBase Ride BikeCam, Instruction Manual

Page: 63 / 68

TROUBLE SHOOTING (CONTD.)
No power to my BikeCam,
but it works upon my PC.
The SD card in my
BikeCam can not be read.
I can't delete files on my
SD card within the
BikeCam.
The screen blanks after a few
minutes upon my
BikeCam.
I get the message “Cluster
size wrong. Please format
SD card” on screen.
The BikeCam can not
lock onto satellite.
The battery only last 30
seconds.
The battery only lasts 6
minutes.
I get the message “Card Error”
on screen.
When I press the MENU
button nothing happens.
Downloading files from
www.nextbase.co.uk
using Google Chrome results
in a Malicious Software
message.
The date & time on my
BikeCam do not adjust for
Daylight Savings time.
Wi-Fi App
Wi-Fi App
The cigarette power cable or hard-wire cable is not working.
Inspect the fuse in the Car Power plug / hard-wire.
Replacement fuse = 2A 20mm type. If the fuse is found to be
blown, inspect the power cable for damage which may have
caused the fuse blow.
Use a good quality branded SD card between 4GB and 32GB and
format the card from with in the SETUP menu of the BikeCam.
Check to see if these files are 'protected', if so please follow
instructions to 'un-protect'.
The screen saver is set to ON. Change settings to OFF if required.
Default setting is off.
The SD card has been formatted in another device and the
Cluster Size is not compatible. Simply use the MENU, SETUP
option to re-format the SD card from within the BikeCam.
After power on and with the device mounted with clear view of the
sky it can take up to 10 minutes to find the three satellites required
to achieve a stable signal. Reception can also be affected by
atmospheric conditions and the proximity of buildings / trees
obscuring the sky.
Please connect the Hard-wire cable, Cigarette Power Cable or
USB Cable to a PC to apply power to your BikeCam.
Charging takes approximately 8 hours and a full charge is
indicated when the Blue LED goes out.
This is normal, the battery design allows the 'Auto Power Off'
feature to function in event of power loss within the vehicle. It is
not intended as an alternative power source to replace the
supplied Cigarette Power cable / Hard-wire cable.
The SD card has become unuseable by the BikeCam.
Remove useful files using your PC and then perform a “FORMAT”
upon the SD card from within the BikeCam SETUP menu.
This is normal during recording. Stop the recording before
pressing the MENU button.
This is not a cause for concern, simply go to the settings within
Google Chrome and turn off the malicious software protection
temporarily to download and install the software.
Reinstate previous Google Chrome settings thereafter.
Correct. The BikeCam will pick up GMT from the satellite signal.
Adjust for Timezone location and Summer Time in the General
Settings Menu.
2 devices can not connect to the BikeCam to review videos.
Correct this is normal.
The second device will become disconnected automatically.
I have changed my BikeCam SSID and password then lost them.
How can I reset ?
No need, when you turn the Wi-Fi on within the BikeCam the new
SSID and password are shown on screen.
PROBLEM SOLUTION
63